โSep-03-2019 09:47 AM
โSep-05-2019 01:35 PM
โSep-04-2019 05:50 PM
โSep-04-2019 04:35 PM
laknox wrote:
Since you have autolevel...
โSep-04-2019 09:08 AM
bpounds wrote:
Loaded or not, you risk blowing the fuse at end of travel. So be quick to get off the button. Be prepared with spare fuses. I've blown a few. Then finally replaced it with an auto-reset breaker that fit the existing socket. But you still need to get off that button quick when finding end of travel. Sneak up on it, don't just slam it. Use your hand crank if desired.
I've never reached full extend, even without using blocks. But I've hit end of retract by not paying attention, even though I marked it with paint.
โSep-03-2019 08:16 PM
โSep-03-2019 06:03 PM
dryfly wrote:Old-Biscuit wrote:
With 5vr still hitched
Raise the Inner tubes up fully
Extend the Outer tubes until you hear then click/clack
Retract then 1" and paint a RED Line -----that is the MAX extension you want to do so you do not damage drive nut/shaft/gears
Are you saying that fully extending the outer legs (without any load on them) until they make a noise, will not damage the gears?
โSep-03-2019 05:01 PM
dryfly wrote:Old-Biscuit wrote:
With 5vr still hitched
Raise the Inner tubes up fully
Extend the Outer tubes until you hear then click/clack
Retract then 1" and paint a RED Line -----that is the MAX extension you want to do so you do not damage drive nut/shaft/gears
Are you saying that fully extending the outer legs (without any load on them) until they make a noise, will not damage the gears?
โSep-03-2019 04:24 PM
Old-Biscuit wrote:
With 5vr still hitched
Raise the Inner tubes up fully
Extend the Outer tubes until you hear then click/clack
Retract then 1" and paint a RED Line -----that is the MAX extension you want to do so you do not damage drive nut/shaft/gears
โSep-03-2019 12:49 PM
โSep-03-2019 12:34 PM
โSep-03-2019 12:06 PM
โSep-03-2019 11:47 AM
โSep-03-2019 11:41 AM
โSep-03-2019 11:36 AM