Hi All,I have a 1995 P32 MH (see below for Mfg data/VIN) and I was going to replace the drag link, but the new recommended part is about 3/8" too long. I've worked with two auto parts stores using the VIN and the listed part is 13.42" long, but the ...
My MH has been constantly idling way too high whether it is hot, cold, etc. I checked the ECM codes and below is what I found:32 - egr circuit (fuel-injected models); DTC - 32 EGR system failure36 - MAF sensor error37 - TCC brake switch circuit erro...
I have a 1995 Georgie Boy Pursuit, 27', 454 TBI with front disc and rear drum brakes. Purchased the rig about 1 year ago and did a complete front end brake job: turned rotors, new ceramic pads, repack bearings, new rubber brake lines, new master cyli...
I have a 1995 Georgie Boy MH on a P32 chassis with 454 eng with TBI. MH only has 37,000 miles and spent the last several months doing extensive maintenance; coil springs, airbags, ball joints, fuel filter, changed/flushed ALL fluids, check spark plu...
I have a 1995 P30 (Georgie Boy - 27') and need to connect a Tekonsha Prodigy brake controller. One of the signals is STOPLIGHT, which tells the brake controller it should engage. I found two switches that operate when the brake pedal is pressed in,...
Finally got around to working on this and the problem turned out to be the butterfly valve being held slightly open by the cruise control cable; not sure how the cable shrunk. I also removed the IAC and cleaned the pintle (it looked very good) and pi...
The rotors were dark blue and trashed from overheating so many times; especially the last. He replaced rotors, calipers, brake pads and master cylinder. $1500 bucks (ouch), but we did not have any brake problems on vacation, so it was worth it. I ...
Mike,Thanks, I will bring this up with the mechanic. I am going on business travel this weekend and need the MH working well as the day I return we are heading to Grand Canyon (BRRRR) for vacation. Tonight on the trip home fron rotors were 300 deg ...
enblethen wrote:Looks like something is sticking.Where did you find the cross reference on the O'Reilly website?Doubt whether it is the hydro boost.Does your rig have a proportioning valve on the rear brakes? It is normally located on right side. Lin...
Oreilly's was only website I've found that could take the GM PN and spit out cross refrenced PNs and Cardone 131982 came up as replacement. So I think the MC is the right PN? Last night I drilled a hole in linkage and sprayed lithium grease - got s...
