Hi there! I have a 1990 Fleetwood bounder, and the monitor panel board is fried. See attached picture. I’m wondering peoples opinions on whether or not I could fix this with some conductive copper foil tape.
Electronics technicians (one hour minimim) 75 to 150/hr.
Home was where I park it. but alas the. 2005 Damon Intruder 377 Alas declared a total loss after a semi "nicked" it. Still have the radios Kenwood TS-2000, ICOM ID-5100, ID-51A+2, ID-880 REF030C most times
I hadn’t considered that. Should I buy the used replacement on eBay for $45, or look into upgrading panels? Is it likely that to upgrade panels, I have to upgrade level sensors, too?
On the topic of why, could a faulty cigarette lighter socket wired into the same circuit as the monitor panel on my Bounder be responsible for melting the ‘pos’ trace on my monitor panel board?