Need help bending edge molding

[Mote]

Hi everyone,
We're just about finished with taking out the front window and replacing all of the rotted wood on the Lance. The new metal is in place. I also bought new molding for the outside edge. I tried putting it on last night but when I come to the rounded part at the nose the molding will buckle. the front leg of the molding is 1" and the side leg is 1/2" which is the same size as the original but this new edging seems a little bit thicker.
Any suggestions on how to get it to bend without buckling?

[midnightsadie]

time flies get to it,

[Mote]

midnightsadie wrote:
x2 and its looking good.

thanks, we're excited that it's almost done. We're leaving for Wyoming in three weeks so I need to get this wrapped up.

[midnightsadie]

x2 and its looking good.

[1995brave]

You need either a metal bender or shrinker/expander. Here is one from HarborFreight .