Ramp angle

[ijon]

I have a prime time fury 2910. When I loan my load or unload my can am Spyder the angle of the ramp is to steep and the bike hangs up. Any simple tip to stop this?

[ijon]

Farmboy666 wrote:
I use my leveling blocks, same as above post but a lot lighter and I carry them anyway.

i think that is a great idea. I have them already and they link together. Thanks.

[Dirtclods]

Maybe three of these would work?











https://www.harborfreight.com/magnum-16000-auto-ramp-set-with-built-in-safety-chock-67722.html

[fj12ryder]

Nice to have some feedback from the OP. Irksome: ask for advice and then disappear.

[beemerphile1]

Raise the front of your RV.

[Farmboy666]

I use my leveling blocks, same as above post but a lot lighter and I carry them anyway.

[Badhabt]

A bit overkill I will admit, but it works on our Raptor and both our Spyder ST-L or our Spyder RT-S. The nose doesnt scrape either on the way up.





Just wish i had a 3d printer and have these made of plastic.

[joebedford]

fj12ryder wrote:
Or add an extension that would flip over when the ramp is down, effectively lessening the approach angle.

yup.

[fj12ryder]

Or add an extension that would flip over when the ramp is down, effectively lessening the approach angle.

On edit, where does it hang up? Top or bottom?

[valhalla360]

Several simple things can be done:
- As mentioned a few boards under the ramp.
- If you can park where the ground is sloping up would do a similar trick
- Alternatively, you could raise the front which will drop the back.
- If you back into the garage, just gun it...ooops sounds fun but maybe not the best idea.

[kerrlakeRoo]

carry a couple of pieces of 2x8 and place them under the ramp where you will roll the bike off.
Raising that end on the ground a couple of inches will ease the angle at the top.