Just replaced my old grey 1.5" waste blade valve along with some abs pipe that was cracked leading up to it.They really cheap out on the rubber for these new seals.The new valve is dripping slowly past the seal to the main waste outlet (not around ho...
I have a relatively new concrete slab that is about 23 by 13'. It is built on a bit of a grade with coordinated drainage pipe underneath.It really is two pieces, 12x13 each. I noticed the side closer to the slope sunk about 1/4" to *gasp* 1/2" near t...
I am putting my Spec E generator back together but can't remember where to route this black 110v hot wire to the breaker switch through.Does anyone know if it just goes with the other harness below the control and regulator plugs on the shield? Or do...
enblethen wrote:Serial number help scroll down it gives a breakdown via serial number for serial number.Ahh yes I tried this and it would indicate my model is a series 10. However the diagrams for 10 don't match.
Yes trying to replace leaky burner and defective ignition flash tubes.Series number is not present on label. Only model and serial.Long shot since they seem unavailable anymore but at least I have peace of mind thay I've got the right part numbers.Pr...
shelbyfv wrote:You are lucky it's just a slab. One corner of my home foundation has sunk, as much as 1/2" depending on the season. From what I read it's going to cost $thousands to have it jacked up and stabilized. Contractors....Haha. Actually I *...
prichardson wrote:What is coordinated pipe? Do you mean corrugated pipe; if so, and it is under the section that is sinking, it may have collapsed.Actually I meant to say perforated pipe. I have looked down from the side where it comes out on the sl...
