With respect to ride height there is a lot of confusion it's measurement. The service manual states no mention of actual load only the rating of the axle. This will be in the motorhome (mine is on closet door 4880lb front axle).When measuring the fro...
Wanted to pass this on in the event someone needs a line made such as trans, brake, hydraulic etc...give 'Morse hydraulics' a call. They are also mobile and can come to you if need be. Great folks.I had (2) lines made for my 4L80E trans here in Kent,...
Looking at the 1994 service manual for 454 TBI under fuel systems (Section 4-4A) the 'Min idle speed' setting is... (Factory set screw)For the 7,4L auto trans in Drive is 625 (+-25rpm) Closed loopControlled Idle Speed is as follows:454 7.4L in Drive ...
The 4K has what is called an 'Throttle stop screw' to adjust it the generator has to be running with no load.Adjustment is as follows:The following is from Micro 4K spec B manual (pg 8-13) same for other 4K models.A throttle stop screw is provided fo...
Sounds as if 1 or more spark plug wires may have burned. Check all your wires carefully. It helps to wrap them with high temp sheaths (8) from the end of the wire. Also check each of your exhaust donuts where the exhaust manifold meets the pipes. The...
enblethen wrote:Have you measured the distance between the rubber bump stop and the crossmember. min of 1.5 inches?I see blue springs. Are they variable rate replacements? If they are, was the rig weighed prior to ordering? if not variable rate, you ...
